L-Band Standalone Fiber Transmitter with SmartMON, 1310nm FP laser

Model: 2408LT13

Directly mount to antenna structure or other outdoor locations
-WP Weatherproof version - does not require secondary enclosure
Wide frequency range for extended L-Band and over the air DTV signals
Protocol independent design - transports all modulation formats
DC pass through and 13VDC modes for LNB power

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

The 2408LT13 is an outdoor fiber optic transmitter for RF signals in the satellite L-Band or wider frequency range. It accepts a single RF input on coaxial cable and provides a single output for optical transmission. Packaged in a compact, standalone enclosure, the 2408LT is ideal for mounting on or near the satellite dish antenna structure. The -WP version features dust and water protection allowing outdoor mounting without a secondary enclosure. A full-power RF monitor output provides a convenient means of obtaining peak satellite signal strength, or additional signal distribution.

Directly mount to antenna structure or other outdoor locations
-WP Weatherproof version - does not require secondary enclosure
Wide frequency range for extended L-Band and over the air DTV signals
Protocol independent design - transports all modulation formats
DC pass through and 13VDC modes for LNB power
LNB current limit & short circuit protection
LNB current monitoring
Minimizes coaxial cable length for superior CNR performance
22kHz tone on/off for LNB local oscillator control
RF monitor output for signal peaking and signal distribution
Manually adjustable or AGC gain modes
Tri-color LED status indicators for Link RF drive strength, LNB voltage and DC input voltage level
SmartMON™ capability provides remote status monitoring via SNMP without a separate data connection
Fiber link provides electrical isolation between antenna and facility mitigating ground loop and lightning issues

Fiber Optic Connector Type - Other
Fiber Optic Signals Supported - Other
Spec Sheet available - Yes

Operating Temperature (Maximum): 158 F
Operating Temperature (Minimum): -4 F
Maximum Frequency Response (Bandwidth): 850000 kHz
Maximum Frequency Response (Bandwidth): 850000000 Hz
Minimum Frequency Response (Bandwidth): 3000000 kHz
Minimum Frequency Response (Bandwidth): 3000000000 Hz
Height: 1.20 in
Width: 2.40 in
Regulatory Compliance: Class 1 laser product, 24CFR 1040.10 and 1040.11, IEC 60825-1, FCC Part 15, Class A, EU EMC Directive (EMI/RFI)
RF Input Number of Inputs: 1
RF Input Connector: F-Type (50ohm BNC Optional)
RF Input Conductor Range: 23-18 AWG (0.26-0.82 mm2)
RF Input Input impedance: 75 ohm (50ohm Optional)
Return Loss 120MHz to 500MHz: > 11dB
Return Loss 500MHz to 3GHz: > 15dB
Input Power Range: -10dBm to -50dBm
Manual Gain Range: +2dB to +30dB in 2dB steps
AGC Hold Range: -8dB to -38dBm ±2dBm
Input IP3: +10dBm
IMD: < -55dBc at -15dB input and minigain
LNB Power Voltage: DC Input-0.5VDC, 13.5VDC, off (selectable)
LNB Power Current: 500 mA
LNB Power Protection: Short Circuit, current limited
LNB Power LO Control: 22kHz on/off (selectable)
RF Monitor Output Number of Outputs: 1
RF Monitor Output Connector: F-Type (50ohm BNC Optional)
RF Monitor Output Conductor Range: 23-18 AWG (0.26-0.82 mm2)
RF Monitor Output Output Impedance: 75 ohm (50ohm Optional)
RF Monitor Output Return Loss: > 15 dB
RF Monitor Output Output Level: Within -2dB of input signal
Optical Output Number of Outputs: 1
Optical Output Connector: Female FC/APC
Optical Output Standard: 1310 Nm
Optical Output CWDM: 1270-1610 Nm
Output Power Standard 1310nm: +2dBm
Output Power CWDM: +2dBm
Output Power RF System Performance2408LT + 7708LRA pair:
Flatness 950MHz to 2150MHz: ±1.5dB
Flatness 120MHz to 3GHz: ±2.0dB
Flatness 326MHz BW to 2.3GHz: ±0.25dB
Flatness Gain Variation Over Temperature: ±2dB (from -20°C to +70°C)
DC Input Voltage: +18VDC nominal, +11V DC to +20V DC range (> LNB min input voltage required when powering an LNB)
DC input power: 2 Watts max excluding LNB Power
DC Input Connector: F-Type
DC Input Conductor Range: 23-18 AWG (0.26-0.82 mm2)
Temperature Dust & Water Protection: IP65 (-WP version only)
Active Power: 2 Watt
DC Voltage: 18 Volts

L-Band Outdoor Fiber Transmitter 98 kb - Data Sheet

Project List

AV-iQ Terms and Conditions | | Powered by AV-iQ

bottom of page