top of page
Pro AV Catalog
Manufacturers
PRODUCT CATEGORIES
Matching Keywords
Model Numbers

Request Quote
All Products
Dual HD/SD-SDI Digital Auto Signal (2x1) Changeover
Model: 500ACO2-HD/SD
- Auto detection of six signal types
- Five modes of operation (including VistaLINK®)
- Auto changeover - two standalone auto changeovers or two link changeovers
- Manual DIP switch control - two independently controlled 2x1 switchers
- GPI Control - two independently GPI controlled 2x1 switchers
Product Info
Tech Specs
Documents
The 500ACO2-HD/SD dual HD/SD Autochangeover is designed to provide extension to the 5600ACO for HD or SD SDI, DVB-ASI, AES audio, bi-level/tri-level syncs and NTSC/PAL video.The unit can also be operated as a standalone changeover unit with two independent 2X1 switchers.The 500ACO uses latching relays to ensure maximum reliability and minimal disruption in the event of any failure.
- Auto detection of six signal types
- Five modes of operation (including VistaLINK®)
- Auto changeover - two standalone auto changeovers or two link changeovers
- Manual DIP switch control - two independently controlled 2x1 switchers
- GPI Control - two independently GPI controlled 2x1 switchers
- ACO Extension - slave unit of the 5600ACO (requires 5600ACO firmware version 1.2 or higher)
- Support for VistaLINK® monitoring and control
- Fully hot-swappable from front of frame with no BNC disconnect required
- Tally output on Frame Status bus upon loss of input signal for quality monitoring
- Latching relays maintain the current path on loss of power
- VistaLINK® capable for remote monitoring via SNMP (using VistaLINK® PRO) when installed in 500FR frame with 500FC VistaLINK® Frame Controller
- Switcher Audio Input Signal Type - AES/EBU
- Switcher Connector Type - BNC
- Switcher Type - Video
- Spec Sheet available - Yes
- Active Power: 6 Watt
- DC Voltage: 12 Volts
- Input Signal Types: Digital
- Number of Inputs: 4
- Number of Outputs: 2
- Number of Ports: 1
- Number of Video Inputs (Digital): 4
- Number of Video Outputs (Digital): 2
- Output Impedance: 10000 ohm
- Standards: SMPTE ST 292-1, SMPTE ST 259-A, B, C, D (143 to 540Mb/s), DVB-ASI, bi-level/tri-level syncs or NTSC/PAL video
- Number of Inputs: 4
- Connector: BNC per IEC 61169-8 Annex A
- Maximum Cable Length: 100m of Belden 1694A or equivalent cable combined input and output
- Return Loss: 10dB up to 1.5Gb/s
- Number of Outputs: 2 passive relay outputs
- DC Offset: 0V ±0.5V
- Inputs: Opto-isolated input with internal pull-up to +5V.
- Outputs: Normally 10k internal pull-up to +5V. Ground to rear panel when relay is in active position.
- Signal Level: +5V nominal
Dual HD/SD-SDI Digital Auto Signal (2x1) Changeover
69 kb
- Data Sheet
Request Quote
Thank you!
Someone will be in touch with you shortly.
Contact USIS AV
close

USIS AV
35 West Jefferson Ave
Pearl River, NY 10965
USA
(845) 358-7755
https://www.usisav.net/
Contact in regards to this product:
Evertz
Model: 500ACO2-HD/SD
Request more information from a dealer near you
close
Request more information from a dealer near you
bottom of page