8-channel HD/SD-SDI, AES & RS-232/422 Auto Change Over

Model: 7700ACO-HD

Auto detection of signal standard
Four modes of operation:Auto changeover - two standalone auto changeovers, Manual DIP switch control - two independently controlled 2x1 switchers, GPI Control - two independently GPI controlled 2x1 switchers, Tally output provided
Protection for 8 channels of AES
Control channels
Protection on HD (1.5Gb/s) or SD (270Mb/s)

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

The Evertz 7700ACO-HD HD/SDI Auto Change Over is designed to provide a HD/SD SDI video, multi channel AES audio and RS-422/RS-232 change over in one device.The unit can be controlled via GPI, remotely via VistaLINK® PRO or set in autochangeover mode.It is an all-in-one ACO package aimed towards protecting a complete channel.(ie. protecting the video, 8 channels of discrete AES and associated control channel (RS-232 or RS-422)).The unit features latching relays that maintain state through loss of power.

Auto detection of signal standard
Four modes of operation:Auto changeover - two standalone auto changeovers, Manual DIP switch control - two independently controlled 2x1 switchers, GPI Control - two independently GPI controlled 2x1 switchers, Tally output provided
Protection for 8 channels of AES
Control channels
Protection on HD (1.5Gb/s) or SD (270Mb/s)
Protection for SMPTE ST 310
Changeover conditions are based on signal presence of:HD/SDI (TRS timing, CRC and EDH), DVB-ASI (SMPTE sync word), Sync (H timing, AES (sync word)
VistaLINK® capable for remote monitoring, control and configuration capabilities via SNMP. VistaLINK® is available when modules are used with the 3RU 7800FR frame and a 7700FC VistaLINK® Frame Controller module in slot 1 of the frame

Spec Sheet available - Yes

Active Power: 6 Watt
DC Voltage: 12 Volts
Standard: SMPTE ST 292-1, SMPTE ST 259 A, B, C, D (143 to 540Mb/s) or DVB-ASI
Number of Inputs: 2
Connector: BNC per IEC 61169-8 Annex A
Equalization: 100m of Belden 1694A or equivalent cable combined input and output
Return Loss: 10dB up to 1.5Gb/s
Number of Outputs: 1 passive relay output
Maximum Cable Length: 60m of Belden 1694A or equivalent cable combined input and output
DC Offset: 0V ±0.5V
INPUT: Opto-isolated input with internal pull-up to +5V
Output: Normally 10k internal pull-up to +5V. Ground to rear panel when relay is in active position
Signal Level: +5V nominal
Serial Port: RS-232/RS-422 - 4 wire
Number of Ports: 4 pins
Level: 1V p-p
Impedance: 75 ohm

8-channel HD/SD-SDI, AES & RS-232/422 Auto Change Over 69 kb - Data Sheet

Project List

AV-iQ Terms and Conditions | | Powered by AV-iQ

bottom of page