Single-slot, card-based RF Fiber Transmitter with SmartMON for wireless applications and
Model: 7708WT13-B50
- DC pass-through 12V DC modes for antenna powering
- High performance
- Low noise floor
- High density, hot-swappable card-based solution
- Light weight standalone modules
Evertz Wireless RF over Fiber series offers flexible solutions to extend RF signals over fiber from wireless microphones, cameras, in-ear-monitors (IEM), intercoms, interruptible fold backs (IFB) to and from centralized control rooms without compromising valuable CNR. This advanced solution offers the flexibility to adapt to different environments and is available in a modular and standalone form-factor.
The standalone transmit and receive modules are compact throw-down devices that are ideal for mounting on or near an antenna structure, as well as any application where rack-based products are not practical. These standalone modules have comprehensive LED indicators that provide status information on the input DC power, RF drive level as well as antenna power status.
- DC pass-through 12V DC modes for antenna powering
- High performance
- Low noise floor
- High density, hot-swappable card-based solution
- Light weight standalone modules
- Protocol-independent design - transports all modulation formats
- Antenna current limit and short circuit protection
- Antenna current monitoring
- RF monitor output for signal peaking and signal distribution
- Manually adjustable or AGC gain modes
- Tri-color LED status indicators for Link RF drive strength, ant. voltage and DC input voltage level
- SmartMON™ capability provides remote status monitoring via SNMP without a separate data connection
- Spec Sheet available - Yes
- DC Voltage: 12 Volts
- Height: 1.20 in
- Length: 5.40 in
- Width: 2.40 in
- RF Input (Tx) Number of Inputs: 1 or 2
- Connector: BNC per IEC 61169-8 Annex A
- Conductor Range: 23-18 AWG (0.26-0.82 mm2)
- Input Impedance: 50ohm (75ohm optional)
- Frequency Range 1310nm DFB Laser: 88 – 2450MHz
- Return Loss: 88 – 500MHz > 12dB, 500MHz-1GHz > 15dB
- Input Power Range: -25dBm to -80dBm
- Manual Gain Range: Standalone 2 – 30dB in 2dB steps, Card-Based 2 – 30dB in 1dB steps
- AGC Hold Range: -8 to -38dBm ±2dBm
- INPUT: IP3 +10dBm
- IMD: < -55dBc at -15dB input and minimum gain
- Noise Figure: 10dBm (@20dBm Tx gain)
- VSWR Average: < 2.5:1
- Input Noise Floor: -104dBm
USIS AV
35 West Jefferson Ave
Pearl River, NY 10965
USA
(845) 358-7755
https://www.usisav.net/