HD SDI to HD Component Analog or Optional VGA Converter

Model: 7731DAC-HD

Support for all SMPTE ST 274 and ST 296 video formats
Full 10-bit Broadcast quality
4:4:4 Interpolated Component Output
Card edge selectable YPrPb/RGB/VGA outputs
GPI controllable 4:3 alignment markers

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

The 7731DAC-HD is a professional quality digital to analog converter for HDTV. The 7731DAC-HD supports all signal standards specified in SMPTE ST 274 and SMPTE ST 296. Card edge control allows the user to select RGB, YPrPb or VGA outputs. User controlled 4:3 alignment markers also allow for convenient framing of the video signal. The 7731DAC-HD is available in two versions to easily interface to standard broadcast monitors or VGA computer monitors.

Support for all SMPTE ST 274 and ST 296 video formats
Full 10-bit Broadcast quality
4:4:4 Interpolated Component Output
Card edge selectable YPrPb/RGB/VGA outputs
GPI controllable 4:3 alignment markers
Optional rear connector plates for use with VGA computer monitors
VistaLINK® capable for remote monitoring, control and configuration capabilities via SNMP; using VistaLINK® PRO, CP-2116E or CP-2232E Control Panels. VistaLINK® is available when modules are used with the 3RU 7800FR frame and a 7700FC VistaLINK® Frame Cont

Converter Signal Types - Video
Converter Type - Digital to Analog Converter
Spec Sheet available - Yes

Serial Video Input - Standard: SMPTE ST 292-1
Serial Video - Number of Inputs: 1
Serial Video Input - Connector: BNC per IEC 61169-8 Annex A
Serial Video Input - Equalization: Automatic 125m @ 1.5Gb/s with Belden 1694A (or equivalent)
Analog Video Output - Standard: SMPTE ST 274, ST 296
Analog Video Output - Signal level: 1V p-p (YPrPb/RGB) or 0.7V p-p (VGA)
Analog Video Output - Sync: 300mV or 4V per nominal
Analog Video Output - Impedance: 75 ohms
Analog Video Output - Connector: 4 BNC per IEC 61169-8 Annex A
Analog Video Output - DC Offset: 0 V ±0.1V
General Purpose Inputs - Type: Opto-isolated, active low with internal pull-ups to Vext pin. May be internally jumpered to +5V
General Purpose - Number of Inputs: 4
General Purpose Inputs - Connector: Male High Density DB-15
General Purpose Inputs - Signal Level: +5 V nominal
Number of Slots: 1
Input Signal Types: Video
Output (Converted) Signal Type: Video
Active Power: 9 Watt
DC Voltage: 12 Volts
Regulatory Compliance: FCC Part 15 Class A, EU EMC Directive

HD SDI to HD Component Analog or Optional VGA Converter 63 kb - Data Sheet

Project List

AV-iQ Terms and Conditions | | Powered by AV-iQ

bottom of page