top of page
Pro AV Catalog
Manufacturers
PRODUCT CATEGORIES
Matching Keywords
Model Numbers
Request Quote
All Products
Dual L-Band RF Fiber Transmitter, 1310nm FP laser, SmartMON™, VistaLINK®
Model: 7807LT13-2
- Extended frequency response for extended L-Band, off-air DTV and other signals
- Protocol independent design - transports all modulation formats
- LNB power with selectable 13/18V DC, per input
- LNB current limit & short circuit protection
- LNB current monitoring for advance warning of LNB failure
Product Info
Tech Specs
Documents
The 7807LT-2 is a dual fiber optic transmitter for RF signals in the extended L-Band or wider frequency range. It accepts two RF inputs from coaxial cable and provides two outputs for optical transmission. An RF monitor output is provided for each input, which offers a convenient means of obtaining peak satellite signal strength, or additional signal distribution. With two optical transmitters per single-slot card, the 7807LT-2 provides a high density economical solution. Individual monitoring and control is provided for each signal path. Gain may be adjusted manually or managed automatically via AGC. With SmartMON™, incoming RF signal strength, LNB current, and other data are relayed over the fiber outputs for monitoring at the receiver side through SNMP/VistaLINK® (requires SmartMON™ capable companion fiber receiver). 13/18V DC selectable LNB power with 22kHz tone is also provided on each RF input.
- Extended frequency response for extended L-Band, off-air DTV and other signals
- Protocol independent design - transports all modulation formats
- LNB power with selectable 13/18V DC, per input
- LNB current limit & short circuit protection
- LNB current monitoring for advance warning of LNB failure
- 22kHz tone on/off for LNB local oscillator control, per input
- RF monitoring output ports for signal peaking and signal distribution
- Manual gain and AGC modes for tuning optimal CNR performance
- Available with 1310nm, 1550nm and CWDM laser options
- Dual fiber transmitters on a single-slot card provides the industry's highest density solution
- SmartMON™ capability provides remote status monitoring via SNMP without a separate data connection
- VistaLINK® capable for remote monitoring via SNMP (using VistaLINK® PRO) when installed in 7800FR frame with a 7700FC VistaLINK® Frame Controller
- Form-C dry contact GPO alarm contacts for monitoring
- Fiber link provides electrical isolation between antenna and facility, mitigating ground loop and lightning issues
- Compatible with all 2406LR, 7706LR, 7708LR and 7807LR-2 series receivers
- The 7807LT-2 occupies one card slot and can be housed in the 1RU 7801FR frame which holds up to four single or two dual slot modules, the 3RU 7800FR frame which has a 15 slot capacity, the portable 3RU 350FR frame which has a 7 slot capacity, or a standalo
- Fiber Optic Connector Type - SC-SC
- Fiber Optic Connector Type - ST-ST
- Fiber Optic Signals Supported - Other
- Spec Sheet available - Yes
- Number of RF Inputs: 2
- RF connectors: BNC per IEC 61169-8 Annex A (F-Type optional)
- RF Input Impedance: 75 ohm
- RF return loss: > 14dB to 2100MHz, > 10dB to 2100MHz to 2800MHz
- RF Frequency Range: 1310nm FP Laser 850MHz-2800MHz
- Input Power Range: -10 to -60 dBm
- AGC Gain Range: -10 to +30 dB
- Input IP3: +10 dBm
- LNB Power Voltage: 13V DC, 18V DC, off (selectable)
- LNB Power Current: 400 mA
- Protection: Short Circuit, current limited
- LO Control: 22kHz on/off (selectable)
- Number of RF Monitor Outputs: 2
- RF Monitor Connector: BNC per IEC 61169-8 Annex A (F-Type optional)
- RF Monitor Output Impedance: 75 ohm
- RF Monitor Return Loss: > 15dB
- RF Monitor Frequency Range: 100 to 2800 MHz
- RF monitor output level: Within -2.0dB of input signal
- Number of Optical Outputs: 2
- Operating wavelength: 1310 Nm
- Output Power: +2 dBm
- Number of General Purpose Outputs: 2
- General Purpose Type: "Dry Contact" relay contacts – normally open & normally closed contact provided
- General Purpose Connector: 3 pin terminal strip
- Power: 6 watts excluding LNB power
- Number of Slots: 1
- DC Voltage: 12 Volts
- Regulatory Compliance: Complies with 24 CFR 1040.10 and 1040.11, Complies with FCC regulations for IEC 60825-1
Dual L-Band RF Fiber Transmitter
65 kb
- Data Sheet
Request Quote
Thank you!
Someone will be in touch with you shortly.
Contact USIS AV
close
USIS AV
35 West Jefferson Ave
Pearl River, NY 10965
USA
(845) 358-7755
https://www.usisav.net/
Contact in regards to this product:
Evertz
Model: 7807LT13-2
Request more information from a dealer near you
close
Request more information from a dealer near you
bottom of page