Low-Cost HDMI Extender Over IP via One LC Singlemode/Multimode Fiber Optic Cable - Local and Remote Unit
Series: XTENDEX
Model: ST-IPFOHD-LC-ULC
- Signal transmission via single-strand LC fiber optic cable. Using singlemode 9-micron cable, extend to 24.8 miles (40 km). Using 50-micron OM3 (or better) multimode cable, extend to 984 feet (300 meters).
- Supports HDTV resolutions to 1080p.
- Cascade network switches to extend the length longer distances. Up to three switches can be cascaded.
- HDMI features supported: HDMI 1.3. 36-bit Deep Color. RGB, YCbCr 4:4:4, and YCbCr 4:2:2. LPCM. Bandwidth up to 4.46 Gbps.
- HDCP 1.4 compliant.
The XTENDEX® HDMI Extender Over IP via Fiber Optic Cable transmits digital video, embedded audio, and IR signals up to 24.8 miles (40 kilometers) away from an HDMI source using a single LC singlemode fiber optic strand or 984 feet (300 meters) using OM3 LC multimode fiber optic cable.
Each HDMI Extender Over IP consists of a local unit that connects to an HDMI source and also supplies video to a local monitor, and a remote unit that connects to an HDMI display. The local and remote units can be connected together for a Point-to-Point connection via Fiber Optic Cable or a Point-to-Many connection via a network switch. Support for multiple transmitters requires a managed network switch.
For more information, visit https://www.networktechinc.com/hdmi-over-fiber.html
- Signal transmission via single-strand LC fiber optic cable. Using singlemode 9-micron cable, extend to 24.8 miles (40 km). Using 50-micron OM3 (or better) multimode cable, extend to 984 feet (300 meters).
- Supports HDTV resolutions to 1080p.
- Cascade network switches to extend the length longer distances. Up to three switches can be cascaded.
- HDMI features supported: HDMI 1.3. 36-bit Deep Color. RGB, YCbCr 4:4:4, and YCbCr 4:2:2. LPCM. Bandwidth up to 4.46 Gbps.
- HDCP 1.4 compliant.
- Full Infrared Remote (IR) control of HDMI source from remote HDTV using existing source remote control.
- For a point-to-many connection, a standalone network with an unmanaged SFP network switch, hub, or router can be used instead of a managed SFP network switch.
- Easily expandable. Add remote units as you add monitors. Up to 253 receivers supported. It is not recommended to use any other network devices on this standalone network as it may cause degradation in performance.
- Support for multiple transmitters (many-to-many connection) requires a managed SFP switch with VLAN support. Standard LAN switches can only support one transmitter.
- The managed SFP switch must support port-based IEEE 802.1Q VLAN.
- Each VLAN acts as a separate HDMI Over IP Channel on the network. Each VLAN channel supports one transmitter. Number of local and remote units that can be used is dependent on the backplane bandwidth of the switch.
- Plug and play installation allows receivers to find the transmitters automatically on the same subnet.
- Local and remote units must be in the same LAN. The units do not support WAN connections.
- Buffered HDMI input loop-through.
- Low RFI/EMI for sensitive applications.
- Built-in default EDID table.
- Cables can be installed in conduit prior to extender installation.
- Integrated mounting brackets for easy surface/wall mounting.
- Extender Type - HDMI
- ROHS Compliant - Yes
- Warranty - Yes
- Spec Sheet available - Yes
- Operating Temperature (Maximum): 140 F
- Operating Temperature (Minimum): -4 F
- Transmission Range: 130944 ft
- Certifications: CE, FCC, RoHS
- AC Voltage (Maximum): 240 Volts
- AC Voltage (Minimum): 100 Volts
- Depth: 3.21 in
- Height: 0.94 in
- Width: 5.43 in
- Warranty (Length/Type): Two years
- Local Unit: One female HDMI connector for source connection. One female HDMI connector for local monitor. Supports HDTV resolutions to 1080p @60Hz. One 3.5mm port for IR emitter (included). IR frequency range: 20 to 60 kHz. One simplex LC fiber optic port for sending/receiving video/audio and IR signals. Supports HDCP 1.4.
- Remote unit: One female HDMI connector for monitor. Supports HDTV resolutions to 1080p @60Hz. One 3.5mm port for IR receiver (included). IR frequency range: 20 to 60 kHz. One simplex LC fiber optic port for sending/receiving video/audio and IR signals. Encoding delay: 100 ms latency. Supports HDCP 1.4.
- Power: Local and remote unit: Input: 100 to 240 VAC at 50 or 60Hz via AC adapter. (Country-specific power supplies included.) Output: US power supply: 5VDC, 2A. UK, EU, AUS power supplies: 5VDC, 3A. Power consumption: 3W each.
- Environmental: Operating temperature: -4 to 140°F (-20 to 60°C). Storage temperature: 22 to 158°F (-30 to 70°C). Operating relative humidity: 0 to 90% non-condensing RH.
- Max Distance: 24.8 miles (40 km) over 9?m singlemode LC fiber optic cable. 984 feet (300 meters) over 50?m OM3 (or better) multimode LC fiber optic cable.
- Cables: Use a simplex LC singlemode 9-micron fiber optic cable to extend the receiver from the transmitter up to 24.8 miles (40 km). Use FIBER-AD-SS-SCFLCM to convert a male simplex SC singlemode connector to a male simplex LC singlemode connector. Use a simplex LC multimode 50-micron OM3 (or better) fiber optic cable to extend the receiver from the transmitter up to 984 feet (300 meters). Use HD-xx-MM cables to connect an HDMI source or display up to 50 feet. Use DP-HD-xx-MM cables to connect a DisplayPort source up to 15 feet. Use DVI-HD-xM-MM cables to connect a DVI source up to 5 meters. Use USB3C-HD4K-xx-MM to connect a USB-C or Thunderbolt 3 device up to 10 feet. Cables not included.
- Package Includes: One transmitter unit. One receiver unit. One T1550/R1310nm 1000 Base-T Gigabit SFP module. One T1310/R1550nm 1000 Base-T Gigabit SFP module. One IR emitter. One IR receiver. Two power supplies.
DVI-D Male to HDMI-A Male Cable - 1 m
DVI-HD-2M-MM
DVI-D Male to HDMI-A Male Cable - 2 m
DVI-HD-3M-MM
DVI-D Male to HDMI-A Male Cable - 3 m
DVI-HD-5M-MM
DVI-D Male to HDMI-A Male Cable - 5 m
HD-10-MM
HDMI Male-male cable - 10 ft; Max Resolution: 4K@60Hz, 1080p@120Hz
HD-15-MM
HDMI Male-male cable - 15 ft; Max Resolution: 4K@60Hz, 1080p@120Hz
HD-25-MM
HDMI Male-male cable - 25 ft; Max Resolution: 4K@60Hz, 1080p@120Hz
HD-30-MM
HDMI Male-male cable - 30 ft; Max Resolution: 1080p@120Hz
HD-3-MM
HDMI Male-male cable - 3 ft; Max Resolution: 4K@60Hz, 1080p@120Hz
HD-50-MM
HDMI Male-male cable - 50 ft; Max resolution: 1080p@120Hz
HD-6-MM
HDMI Male-male cable - 6 ft; Max Resolution: 4K@60Hz, 1080p@120Hz
USIS AV
35 West Jefferson Ave
Pearl River, NY 10965
USA
(845) 358-7755
https://www.usisav.net/