Low-Cost HDMI Over Gigabit IP Extender with IR and Power over Ethernet (POE) (Next Generation Model)
Series: XTENDEX
Model: ST-IPHD-POELC-V4
- Supports HDTV resolutions to 1080p. Extend up to 394 feet (120 meters) with CAT6/6a/7 cable. Extend up to 328 feet (100 meters) with CAT5e cable.
- Cascade network switches to extend the length long distances. Up to three switches can be cascaded.
- The max cable length between the first switch/transmitter and the last switch/receiver is 1,575 feet (480 meters) for CAT6/6a/7 or 1,312 feet (400 meters) for CAT5e cables. The max cable lengths between switches is switch dependent, but 394 feet (120 mete
- Power over Ethernet (PoE) – power supply not required at the local or remote unit.
- Ideal solution for digital signage applications.
The XTENDEX® Low-Cost HDMI Over Gigabit IP Extender with IR and POE multicasts digital video and audio signals to one or more receivers up to 394 feet away over a 1000 Base-T Gigabit Network connected with CAT6/6a/7 cable.
Each Low-Cost HDMI Over Gigabit IP Extender with IR and POE consists of a local unit that connects to an HDMI source, and a remote unit that connects to an HDMI display. The local and remote units can be connected together for a Point-to-Point connection via CATx or a Point-to-Many connection via a network switch. Support for multiple transmitters requires a managed network switch.
NOTE: ST-IPHD-POELC-V4 models are NOT compatible with ST-IPHD-POELC(-CLR) models due to different chipsets being used.
For more information, visit https://www.networktechinc.com/hdmi-ip-poe.html
- Supports HDTV resolutions to 1080p. Extend up to 394 feet (120 meters) with CAT6/6a/7 cable. Extend up to 328 feet (100 meters) with CAT5e cable.
- Cascade network switches to extend the length long distances. Up to three switches can be cascaded.
- The max cable length between the first switch/transmitter and the last switch/receiver is 1,575 feet (480 meters) for CAT6/6a/7 or 1,312 feet (400 meters) for CAT5e cables. The max cable lengths between switches is switch dependent, but 394 feet (120 mete
- Power over Ethernet (PoE) – power supply not required at the local or remote unit.
- Ideal solution for digital signage applications.
- Broadcast real-time HDMI video and audio signals to multiple display locations with a managed or unmanaged (also known as non-managed) network switch.
- Transmits an HDMI signal over one CATx cable.
- Full Infrared Remote (IR) control of HDMI source from remote HDTV using existing source remote control.
- Plug-and-Play installation allows receivers to find the transmitters automatically on the same subnet. (Network configuration may be required for managed network switch.)
- Easily expandable. Add remote units as you add monitors.
- Inexpensive CATx cable replaces bulky video cables.
- Supports 1000 Base-T Ethernet connection.
- Built in default EDID table.
- HDMI 1.4 and HDCP 1.4 compliant.
- Support for multiple transmitters requires a managed network switch with VLAN support. Standard LAN switches can only support one transmitter.
- The managed switch must support port-based IEEE 802.1Q VLAN. Each VLAN acts as a separate HDMI Over IP Channel on the network. Each VLAN channel supports one transmitter. Number of local and remote units that can be used is dependent on the backplane
- For a point-to-many connection, a standalone network with an unmanaged network switch, hub, or router can be used instead of a managed network switch.
- Up to 253 receivers supported. It is not recommended to use any other network devices on this standalone network as it may cause a degradation in performance.
- Local and remote units must be in the same LAN. The units do not support WAN connections.
- NOTE: ST-IPHD-POELC-V4 models are NOT compatible with ST-IPHD-POELC(-CLR) models due to different chipsets being used.
- ROHS Compliant - Yes
- Warranty - Yes
- Spec Sheet available - Yes
- Operating Temperature (Maximum): 140 F
- Operating Temperature (Minimum): 32 F
- Transmission Range: 394 ft
- Certifications: CE, FCC, RoHS
- AC Voltage (Maximum): 240 Volts
- AC Voltage (Minimum): 100 Volts
- Depth: 3.71 in
- Height: 0.94 in
- Width: 4.44 in
- Local Unit: One female HDMI-A port for source connection. One female 1000Mbps RJ45 port for sending high definition video/audio signals. One female 3.5mm port for IR emitter (included). IR frequency range: 20 to 60 Khz. Supported input resolutions: 480i@60Hz, 480p@60Hz, 576i@50Hz, 576p@50Hz, 720p@50/60Hz, 1080i@50/60Hz, 1080p@50/60Hz. Encoding delay: 80 ms latency. Supports HDCP 1.4.
- Remote unit: One female HDMI-A port for HDTV or computer display. One female 1000Mbps RJ45 port for receiving high definition video/audio signals. One female 3.5mm port for IR receiver (included). IR frequency range: 20 to 60 Khz. Supported output resolutions: 480p@60Hz, 576p@50Hz, 720p@50/60Hz, 1080p@50/60Hz. Supports embedded digital audio through HDMI compatible TVs or audio receivers. Supports HDCP 1.4.
- Power: Power over Ethernet: With a switch that supports Power over Ethernet, a power supply is not required at the local or remote unit. Compliant with IEEE 802.3af, class 0 standards. Local and remote unit: Input: 100 to 240 VAC at 50 or 60 Hz via AC adapter (not included). Country-specific AC adapter sold separately (PWR-SPLY-IPHDPOELCV4). Output: 5VDC, 3.0A. Power consumption: Local: 4.5W. Remote: 3.5W.
- Max Distance: 394 feet (120 meters) over CAT6/6a/7 cable. 328 feet (100 meters) over CAT5e cable.
- Cables: Use HD-xx-MM cable to connect an HDMI source or display up to 50 feet. Use HD-ACT-xx-MM 4K HDMI Active Cables to connect an HDMI source or display up to 100 feet. Use DP-HD-xx-MM cables to connect a DisplayPort source up to 15 feet away from the transmitter. Use DVI-HD-xx-MM cable to connect a DVI source up to 5 meters. Use CATx solid or stranded straight through cable for TIA/EIA-568B wiring terminated with standard RJ45 connectors. Extend to 394 feet (120 meters) over CAT6/6a/7 cable. Extend to 328 feet (100 meters) over CAT5e cable. Cables not included.
- Environmental: Operating temperature: 32 to 140°F (0 to 60°C). Storage temperature: -4 to 158°F (-20 to 70°C). Operating and storage relative humidity: 0 to 95% non-condensing RH.
DVI-D Male to HDMI-A Male Cable - 1 m
DVI-HD-2M-MM
DVI-D Male to HDMI-A Male Cable - 2 m
DVI-HD-3M-MM
DVI-D Male to HDMI-A Male Cable - 3 m
DVI-HD-5M-MM
DVI-D Male to HDMI-A Male Cable - 5 m
HD-10-MM
HDMI Male-male cable - 10 ft; Max Resolution: 4K@60Hz, 1080p@120Hz
HD-15-MM
HDMI Male-male cable - 15 ft; Max Resolution: 4K@60Hz, 1080p@120Hz
HD-25-MM
HDMI Male-male cable - 25 ft; Max Resolution: 4K@60Hz, 1080p@120Hz
HD-30-MM
HDMI Male-male cable - 30 ft; Max Resolution: 1080p@120Hz
HD-3-MM
HDMI Male-male cable - 3 ft; Max Resolution: 4K@60Hz, 1080p@120Hz
HD-50-MM
HDMI Male-male cable - 50 ft; Max resolution: 1080p@120Hz
HD-6-MM
HDMI Male-male cable - 6 ft; Max Resolution: 4K@60Hz, 1080p@120Hz
USIS AV
35 West Jefferson Ave
Pearl River, NY 10965
USA
(845) 358-7755
https://www.usisav.net/